Common Sources Of Water Damage in a Bathroom


This great article following next on the subject of Preventing Water Damage in the Bathroom is indeed compelling. Read it for yourself and figure out what you think of it.

Common Causes of Water Damage in a Bathroom
The shower room is extremely prone for wet accumulation as well as possible water damage because of the regular use water in it. This short article provides basic examination techniques to assist finding water damages hazards.
The regular use water in the washroom makes it extremely at risk for moist build-up as well as possible water damages. By inspecting it frequently, you can lower water relevant damages.
The complying with set of assessments is very easy to perform and ought to be done once in every three months in order to keep your bathroom in good shape and to prevent potential water damages caused by the tub, the shower, pipe joints as well as plumbing, sinks, cupboards, and the commode
Do not forget executing these examinations and also be detailed while executing them. Remember that these basic assessments can save you a lot of money by providing very early signs for water damages

Sinks as well as Cabinets

Sinks and cabinets are exposed to dampness and also moisture everyday and are often forgotten. Evaluate on a regular basis under the sink as well as on the counter top over it. Repair any type of drip in the trap as it may recommend drainpipe troubles. Browse the sink, sluggish draining pipes may show an obstructed drainpipe. Change sink seals if they are fractured or loosened.

Tub as well as Shower

The shower and bathtub call for unique interest and maintenance. Examine the floor tiles as well as replace if cracked. See to it that there is no missing out on cement between the tiles. Evaluate as well as replace cracked caulking at joints where the wall surfaces satisfy the floor or the bathtub. Obstructed drains pipes and pipelines problems will certainly stop the bathtub from drying out and might suggest serious issues beneath the bath tub. Speak with a specialist right away to stop structural damages. Take note of stainings or soft areas around the bath tub walls as they might indicate an inner leak.


Signs for water damages are hard to find since many pipelines are installed inside the wall surfaces.
Pay unique interest to floor covering and wall surfaces moisture as well as stains as they may show an unnoticeable plumbing trouble. Check wetness degrees in adjoining areas as well.

The Bathroom

The commode is a susceptible water joint. Check the water lines as well as look for leaks around the bathroom seat, in the tube, and under the water storage tank. If you identify any indications of dampness on the floor around the bathroom, look for leaks in the toilet rim as well as container seals.
Understand that hanging bathroom dish deodorants enhances the opportunities for clogs.

How to prevent bathroom water damage

Water damage is unique in that it builds up over an extended period of time, eventually leading to outbreaks of mould, softening of walls and ceilings, cracks in sealant and tiles, and distortion of base floors and frames.

Bathroom water damage is incredibly common, as we often don’t realise it’s happening until something major happens to attract out attention, such as a bulge appearing in the ceiling or the sealant connecting your bath to the floor becoming cracked.

We spread a lot of excess water around in our bathrooms, which seeps into tiny pores and cracks in all sorts of surfaces where conditions make drying difficult. Besides actual surface water, the steam which billows from our hot showers and freshly-run baths takes its toll as well over time.

Any leaking fixtures, such as taps, showerheads, or toilets, allow water to seep into cracks on floors, walls, and tiles – where mould can begin to bloom and rot sets in.

If you are a concerned homeowner looking to keep your bathroom in tip-top shape for an upcoming inspection, sale, or simply for your own enjoyment, this article will teach you how to identify and repair risks associated with water damage in your bathroom.

  • 1. Keep your towel close to the shower/bath, and dry yourself off whilst still standing in the shower or bath. If you step out of the bath or shower, have a towel or bathmat on the floor for you to stand on. This stops excess water gathering on the floor and being splashed on walls.

  • 2. Make sure that the extraction fan is switched on. This sucks some of the steam out of your bathroom, preventing condensation build-up on walls, ceilings, and floors. If your fan is faulty or broken, have it replaced as soon as possible.

  • 3. If you think your toilet might be leaking, switch off the shutoff valve when you’re not using it. It can be difficult to spot toilet leaks sometimes, but if you hear a low, steady hiss coming from the tank, excess water is leaving the tank. Though this water is probably just going down the drain, any cracks or fissures in the bowl will cause small, constant leaks that can do significant damage to surrounding surfaces over time.

  • 4. Try and clean your bathroom at least once a week. This includes wiping down surfaces with a cloth and then drying them thoroughly once you’re done. This will prevent mould and rot from setting in and damaging the surfaces in your bathroom.

  • Check that sealant and grout are intact

    Grout and sealant are the materials which fix your bathroom fittings in place, such as shower cubicles, bathtubs, and tiles. Regular prolonged exposure to moisture and heat in the bathroom can cause grout to crack and wear out. Check the grout and sealant regularly to make sure it’s free of stains and rot. Use a cleaning solution to clean the grout when you are doing the housework, and dry it thoroughly when you’re finished.

    If you notice grout is missing or extensively damaged, you should remove any worn-out gout and clean the area thoroughly. Give it a good dry and let it sit for a bit, and then install new grout. This will prevent rot from spreading and stop your fixtures or tiles from shifting.

    Check regularly for leaking pipes or spouts

    If you see water dripping from a pipe or other fitting, you should have it repaired as quickly as you can. You can probably do it yourself by tightening the fittings or applying a plumbing putty or sealant.

    Even small leaks become progressively worse over time, and the water they leak can accumulate underneath the floor or behind walls. If you are unsure about the extent of a leak, you should contact a professional blocked drain plumber for diagnosis and repair.

    Check for leaks around the toilet and bath

    When a bath, shower cubicle, or toilet are installed they are caulked into the floor. It’s important that you check this caulking regularly to make sure that it’s in good condition. If the caulk becomes damaged, the fixtures will leak and moisture will accumulate. Eventually this can cause the fixtures to shift and damage the floor, leading to further water damage.

    Look for any signs of decay or rot

    When you’re using or cleaning your bathroom, keep an eye out for any indication that rot, mould, or other forms of decay might be setting in. If you notice stains on surfaces or sealant, you will need to take action.

    Make sure that there aren’t any loose tiles

    Tiles in shower cubicles are particularly prone to coming loose. Make sure that all the tiles in your bathroom are fitting tightly and are adequately caulked. If you notice loose or shifting tiles, remove them as soon as you get the chance, clean and dry the area, and replace the tiles. You can use the same tiles you removed, just make sure you clean and dry them thoroughly before you replace them.

    Check under the sink

    This is an important one. Make sure that you look under your sink occasionally to make sure that the pipes and fittings there are in good condition. If they aren’t, water can accumulate in this space and spread rot to other surfaces. It can also damage the foundations of the sink fitting and damage the floor.

    Install drain covers

    Drain covers have a very important place in every bathroom. They work by keeping large particles, such as dirt clumps and hair, out of the drains where they could cause blockages. You probably already have drain covers over your drains, so make sure that they are kept clean and clear of debris. This will prevent any blockages from occurring in the drain, which could cause leaks and internal flooding.

    How to Repair and Prevent Bathroom Water Damage

    As a keen reader about How to Fix a Water Damage Bathroom, I was thinking sharing that excerpt was appropriate. Sharing is caring. Helping people is fun. I cherish reading our article about Preventing Water Damage in the Bathroom.

    Request Appointment

    Leave a Reply

    Your email address will not be published. Required fields are marked *